RH
Relative humidity sensor
A relative humidity sensor measures moisture in air relative to the saturation condition at the relevant temperature.
Schematic
Functional block · SRDI
Switchroom roof-leak detection interface
Functional block · Switchrooms
An independently authored application reference. The drawing shows the named function or circuit relationship; use the project legend and selected equipment documentation for its drafting form and connections.
Browse this installation focusIn plain English
What this block does
Maps the assigned overhead leak-detection circuit to its room alarm point.
A simple example
In a switchroom, water ingress, temperature, humidity and equipment-service alarms can be sent to the station controller with separate point names so an operator can identify the affected area. For this reference, the drawing identifies “Roof leak detector” at the input and “Leak location alarm” at the output. The sensing coverage must be identified.
What the drawings help you do
Start at the named input: Roof leak detector. Identify its source device or document and the state represented on the drawing. Follow the named output: Leak location alarm. Cross-reference its destination and separate the command from confirmation that the equipment responded.
- Input
- Roof leak detector
- Output
- Leak location alarm
- Application reference
- An explanation of a named drawing function or circuit relationship; the project documents define the equipment and its connections.
Read the source: Ventilation in MV substations
Schematic · SRDI
What it represents
Maps the assigned overhead leak-detection circuit to its room alarm point. Environmental supervision turns measurements or contact states into clearly named room-service indications. A sensor measures a condition; the supervisory function decides whether the assigned alarm or control response is needed.
In a switchroom, water ingress, temperature, humidity and equipment-service alarms can be sent to the station controller with separate point names so an operator can identify the affected area. For this reference, the drawing identifies “Roof leak detector” at the input and “Leak location alarm” at the output. The sensing coverage must be identified.
Keep sensor location, alarm thresholds, delay and monitoring coverage in the room-services schedule. An environmental alarm is a diagnostic input, not a complete assessment of electrical equipment condition. The functional block is an independent explanation of this named application. Equipment-specific ratings, terminal connections and operating conditions must be established in the project documentation.
How to read it
- Start at the named input: Roof leak detector. Identify its source device or document and the state represented on the drawing.
- Follow the named output: Leak location alarm. Cross-reference its destination and separate the command from confirmation that the equipment responded.
- The sensing coverage must be identified.
- Keep sensor location, alarm thresholds, delay and monitoring coverage in the room-services schedule. An environmental alarm is a diagnostic input, not a complete assessment of electrical equipment condition.
Information to show or reference
- Label the source and connection reference for roof leak detector.
- Identify the destination and defined state of leak location alarm.
- Record the equipment or control-document revision supporting this functional block.
- Check this application limit in the project design: The sensing coverage must be identified.
A distinction that matters
The sensing coverage must be identified. This reference describes the named application; it does not establish a new IEC graphical symbol, an ANSI device-function number or an exact manufacturer connection diagram.
Sources you can follow
These public references support the explanation and provide further detail. Their graphics and downloadable files remain with their publishers.
Ventilation in MV substations
Public technical context for switchroom environmental supervision. Heat removal, condensation and environmental design context. The application text and educational graphic are independently authored; the publisher does not certify this representation.
About this graphic
This illustration was authored independently by Elora Grid to explain the concept. It is not reproduced from a customer drawing, an official standard graphic or a manufacturer CAD file. Its correspondence to an exact IEC or IEEE symbol identifier has not been certified.
SVG and DXF downloads contain this original artwork. Original artwork is available under CC BY 4.0. Third-party references retain their own terms.
Explore related references
Put the reference into a drawing workflow.
Elora Grid helps electrical teams work with drawings, specifications and equipment information. Explore the drafting workflow or join the early-access waitlist.